EBDN - Community - Question & Answers
0
Undo
Votes
Sir,
This is in relation with a observation related to using formula attribute in a wire stencil. We are using this for our customer
EB version used EB 6.7.0
We have used a formula attribute in a wire stencil. This is used to show the wire destination as required by the customer (standard as we get in EB i.e. Destination 1 and Destination 2 is not used)
We are using a program to place this wire tag in the document. However our observation is that after placement the Formula attribute used doesn’t appear for the wire. Pl refer the image below,
Here the only one destination L2pH 4 which is standard destination 1 as we get in EB. The destination 2 doesn’t appear.
When we manually disconnect the connection and redo the connection again the formula attribute appears for the wire. Pl refer the picture below,
As mentioned we have used formula attribute in wire stencil hence we see different destinations.
Kindly refer the attached document for images
Kindly let us know solution for the same.
This is in relation with a observation related to using formula attribute in a wire stencil. We are using this for our customer
EB version used EB 6.7.0
We have used a formula attribute in a wire stencil. This is used to show the wire destination as required by the customer (standard as we get in EB i.e. Destination 1 and Destination 2 is not used)
We are using a program to place this wire tag in the document. However our observation is that after placement the Formula attribute used doesn’t appear for the wire. Pl refer the image below,
Here the only one destination L2pH 4 which is standard destination 1 as we get in EB. The destination 2 doesn’t appear.
When we manually disconnect the connection and redo the connection again the formula attribute appears for the wire. Pl refer the picture below,
As mentioned we have used formula attribute in wire stencil hence we see different destinations.
Kindly refer the attached document for images
Kindly let us know solution for the same.